How to Turn on or off Alerts for a Project

How to Turn on or off Alerts for a Project



To Maintain Alerts for a Project

Access the Alert Settings under the Concrete Type






After selecting the Concrete Type, Click on Target Alerts button



You can now check or uncheck any of the Alerts or change the email/group id, etc.






Remember to Click OK



If you click on Config Adv Alerts, you can configure and activate Alerts that are very specific to your project(s).

This is a special Alert setting that allows users to change the default setting of how often Alerts are repeated for a specific project:



You can select a Color that will cause the Location or Serial Number to display with this background color if either an advanced alert has occurred or in the case of this setting to change the time in elapsed minutes that a repeating Alert will occur.

Here are (2) examples of Advanced Alerts for Thermal Shock:






These Advanced Alerts can be Activated and as well as deactivated by using the checkbox on the Alert, following the Alert number.

Although this does look complex, after these Advanced Alerts are setup, you can copy them to future projects or just SaveAs a project and both the Devices and the Alerts will copy to your new project.

Note: It is recommended that you consult with Wake Customer Care to set up Advanced Alerts for the first time.


Now Click Save



Close the Concrete Type form





If you are using Concrete maturity, click Yes to this message, otherwise, if you a just monitoring temperature, click No



Click yes to Save Project


_______________________________________________________________________________________________________________________________________________________________________________

Wake, Inc. 2885 Sanford Ave SW #27245, Grandville, MI 49418-1342  US (800) 957-5606 CA (647) 931-6995 Fax (877) 900-0189 www.wakeinc.com