Replacing the backup battery in the HTC II
Battery Safety
Prior
to installation, the battery should be inspected for any signs of damage. If
the battery appears to be damaged or is dropped during the installation, do not
use the battery and dispose of it properly.
Always
use the batteries supplied by Wake, Inc.
Do
not attempt to recharge the HTC II's backup lithium battery, as it could
explode.
When
the HTC II device is installed in C1D2 environments, flammable gas environments,
do not disconnect the battery until the environment around the HTC II is vented
or known to be free of any flammable gas concentrations.
1. Open the enclosure.
2. Disconnect
the battery.
a. Press in the tab at the top of the battery wire connector.b. Pull up on the connector.
3. Remove the existing
battery.
4. Place the
new battery in the battery holder and connect the wiring to the battery port.
Make sure the battery and its wiring are properly placed.
Related Articles
Understanding the Battery Life of your HardTrack Cloud Sensor devices
How the replaceable battery works in the HTC devices : HTC - HardTrack Cloud Sensor: - HTC lithium batteries experience passivation when the battery is not used for a period of time. Battery passivation can cause the battery to report a low battery ...How to Prolong Rechargeable Battery Life for HTCII Devices
It is important to understand that a fully charged battery depletes at a much slower rate than a battery that has 45% or less power remaining. The batteries deplete very fast after 45% power remaining. When the batteries are at 97% to 60% power ...Shipping the HTC II - Ground Only!
When you ship the HTC II, due to DOT regulations, they must be shipped ground only with the following labels. Each carton must include all (3) of these labels: a label stating that it is forbidden for transport aboard aircraft and vessels. a UN ...Factors that determine Battery Life for the HardTrack Cloud Sensor devices - How to Extend Battery Life
Cellular signal strength. Weaker cellular signals sometimes require multiple attempts to connect and upload data, which will deplete the battery faster than in areas where there is a strong cellular signal. Physical length of each temperature sensor ...How to Switch a Single Sensor on a Project to a Backup Sensor
An ideal way to set up concrete temperature monitoring with HardTrack, is to attach your backup sensors to the HardTrack Cloud (HTC) Device so that if you need to switch from the primary to the backup sensor, you can do so remotely without any ...